- Apply
- Visit
- Request Info
- Give
Product Name: STAINLESS STEEL CLEANER AND POLISH (AEROSOL)
Product Number: 6310
Product Division: Janitorial
Shipping Description: ORM-D, Consumer commodity, cleaning compounds, aerosol, n.o.s.
Spartan Chemical Company, Inc.
1110 Spartan Drive, Maumee, OH 43537
Product/Technical Information: 1-800-537-8990
Medical Emergency: 1-888-314-6171 (24 hours)
Chemical Leak/Spill Emergency (CHEMTREC): 1-800-424-9300 (24 hours)
NFPA Ratings:
Health: 1 - Slight
Fire: 0 - Minimal
Reactivity: 1 - Slight
HMIS Ratings:
Health: 1 - Slight
Fire: 0 - Minimal
Reactivity: 1 - Slight
Personal Protective Equipment: A - Safety Glasses
Listed when present at 1% or greater; carcinogens at 0.1% or greater. All component chemicals are listed or exempted from listing on the TSCA Inventory of chemical substances maintained by the U.S. Environmental Protection Agency.
Chemical Name: Odorless mineral spirits
% W: 05–10
CAS Registry No.: 8052-41-3
TWA mg/m³: 350 (NIOSH)
STEL mg/m³: Not Established
Ceiling mg/m³: 1800 (NIOSH)
Carcinogen: No
Chemical Name: Propane
% W: 05–10
CAS Registry No.: 74-98-6
TWA mg/m³: 1800
STEL mg/m³: Not Established
Ceiling mg/m³: Not Established
Carcinogen: No
Chemical Name: Isobutane
% W: 01–05
CAS Registry No.: 75-28-5
TWA mg/m³: 1900 (NIOSH)
STEL mg/m³: Not Established
Ceiling mg/m³: Not Established
Carcinogen: No
Boiling Point: N/A
Vapor Pressure: Unknown
Vapor Density (Air = 1): Unknown
Solubility in Water: Forms an emulsion
pH: 8.8
Specific Gravity (H₂O = 1): 0.97
Evaporation Rate (Butyl Acetate = 1): >1
Percent Solid by Weight: 7–9
Physical State: Liquid
Appearance & Odor: Creamy sprayed film, lemon fragrance
Flash Point: None
Method Used: ASTM-D56
Flammable Limits: N/A
Flame Extension: N/A
Extinguishing Media: Water fog, dry chemical, CO₂
Special Fire Fighting Procedures: Use equipment or shielding required to protect personnel against bursting, rupturing, or venting containers.
Unusual Fire & Explosive Hazards: At elevated temperatures (over 54 °C / 130 °F) container may vent, rupture, or burst.
Threshold Limit Value: Not Established
Primary Routes of Entry: Inhalation, Skin Contact
Effects of Overexposure / Conditions to Avoid: Avoid skin and eye contact; may cause skin or eye irritation.
Conditions Aggravated by Use: Unknown
Eyes: In case of contact, flush eyes with water for at least 15 minutes. Remove contact lenses.
Skin: Wash off in flowing water or shower. Wash clothing before reuse.
Ingestion: Induce vomiting if large amounts are ingested. Seek medical attention.
Stability: Stable
Incompatible Materials: Oxidizing material; acids
Hazardous Decomposition Products: None known
Hazardous Polymerization: Will Not Occur
Steps if Material is Released or Spilled: Dilute with water and flush into sanitary sewer system.
Waste Disposal Method: Do not incinerate or puncture aerosol container. Dispose of in accordance with state or local regulations.
Respiratory Protection: None required
Ventilation: Good general ventilation should be sufficient for most conditions. Local exhaust ventilation may be necessary for some operations.
Protective Gloves: None required
Eye Protection: Safety glasses while spraying
Other Protective Equipment: None required
Precautions - Handling & Storing: Contents under pressure. Do not use near fire, sparks, or flame. Do not store where temperatures could exceed 120 °F.
Other Precautions: None
© SCC 11/05/99
Prepared by: Ronald T. Cook, Manager, Regulatory Affairs
Effective Date: 11/05/99
Supersedes: 09/24/99
Changes: Section II correction
Reference: 29 CFR 1910.1200 (OSHA)
This document has been prepared using data from sources considered technically reliable. It does not constitute a warranty, express or implied, as to the accuracy of the information contained herein. Actual conditions of use and handling are beyond sellers control. User is responsible to evaluate all available information when using product for any particular use and to comply with all Federal, State and Local laws and regulations.