- Apply
- Visit
- Request Info
- Give
Product Name: SHINELINE SEAL
Product Number: 4004
Product Division: Janitorial
Shipping Description: Buffing, polishing compounds, liquid, n.o.s.
Spartan Chemical Company, Inc.
1110 Spartan Drive, Maumee, OH 43537
Product/Technical Information: 1-800-537-8990
Medical Emergency: 1-888-314-6171 (24 hours)
Chemical Leak/Spill Emergency (CHEMTREC): 1-800-424-9300 (24 hours)
NFPA Ratings:
Health: 1 - Slight
Fire: 0 - Minimal
Reactivity: 0 - Minimal
HMIS Ratings:
Health: 1 - Slight
Fire: 0 - Minimal
Reactivity: 0 - Minimal
Personal Protective Equipment: B - Safety Glasses; gloves
Listed when present at 1% or greater; carcinogens at 0.1% or greater. All component chemicals are listed or exempted from listing on the TSCA Inventory of chemical substances maintained by the U.S. Environmental Protection Agency.
Chemical Name: *Dibutyl phthalate
% W: 1.6
CAS Registry No.: 84-74-2
TWA mg/m³: 5
STEL mg/m³: Not Established
Ceiling mg/m³: Not Established
Carcinogen: No
Chemical Name: *Diethylene glycol monoethyl ether
% W: 6.5
CAS Registry No.: 111-90-0
TWA mg/m³: Not Established
STEL mg/m³: Not Established
Ceiling mg/m³: Not Established
Carcinogen: No
*Dibutyl phthalate and Diethylene glycol monoethyl ether are subject to the reporting requirements of Section 313 of the Emergency Planning and Community Right-To-Know Act of 1986 (SARA) and of 40 CFR 372.
Boiling Point: 210 °F
Vapor Pressure: 18 mm Hg @ 75 °F
Vapor Density (Air = 1): Unknown
Solubility in Water: Complete
pH: 8.0–8.5
Specific Gravity (H₂O = 1): 1.029
Evaporation Rate (Butyl Acetate = 1): <1
Percent Solid by Weight: 24–26
Physical State: Liquid
Appearance & Odor: Milky emulsion, acrylic odor
Flash Point: None
Method Used: ASTM-D56
Flammable Limits: N/A
Flame Extension: N/A
Extinguishing Media: N/A
Special Fire Fighting Procedures: N/A
Unusual Fire & Explosive Hazards: N/A
Threshold Limit Value: Not Established
Primary Routes of Entry: Inhalation, Skin Contact
Effects of Overexposure / Conditions to Avoid: Vapors may be irritating to eyes and respiratory tract and may produce symptoms of headache and nausea in poorly ventilated areas.
Conditions Aggravated by Use: Unknown
Eyes: In case of contact, immediately flush eyes with water for at least 15 minutes. Remove contact lenses. If irritation persists, call a physician.
Skin: In case of skin contact, flush skin with water.
Ingestion: If swallowed, drink large quantities of water and call a physician.
Stability: Stable
Incompatible Materials: None known
Hazardous Decomposition Products: None known
Hazardous Polymerization: Will Not Occur
Steps if Material is Released or Spilled: Flush with water through sanitary sewer system.
Waste Disposal Method: Same as above.
Respiratory Protection: Not normally required
Ventilation: Good general ventilation should be sufficient for most conditions. Local exhaust ventilation may be necessary for some operations.
Protective Gloves: Impervious gloves
Eye Protection: Safety glasses
Other Protective Equipment: None required
Precautions - Handling & Storing: Keep from freezing.
Other Precautions: None
© SCC 09/29/99
Prepared by: Ronald T. Cook, Manager, Regulatory Affairs
Effective Date: 09/29/99
Supersedes: 02/11/98
Changes: Address and Format
Reference: 29 CFR 1910.1200 (OSHA)
This document has been prepared using data from sources considered technically reliable. It does not constitute a warranty, express or implied, as to the accuracy of the information contained herein. Actual conditions of use and handling are beyond sellers control. User is responsible to evaluate all available information when using product for any particular use and to comply with all Federal, State and Local laws and regulations.